So it's important to match it with compatible devices.
Locate the Learn Button: Remove the liftmaster learn button light cover or check the back panel to find the button.
Press the Learn Button: Press and release the Learn button. The LED light next to it will illuminate for about 30 seconds, indicating it's in programming mode.
Activate the Remote: Within the 30-second window, press and hold the button on your remote control that you wish to program.
Confirmation: The garage door opener lights will blink, or you may hear a clicking sound, indicating successful programming.
Test the Remote: Press the remote button again to confirm it opens and closes the garage door properly.
Programming a Keyless Entry Keypad with the Learn Button
Press the Learn Button: Locate and press the Learn button until the LED turns on.
Enter a New Code: On the keypad, enter your preferred 4-digit code and press the enter button.
Confirmation: The opener light should blink, or you may hear a clicking noise.
Test the Keypad: Enter the 4-digit code followed by the enter button to check if the garage door opens.
Erasing All Codes from the LiftMaster Opener
If you need to reset the system or remove access for lost remotes, follow these steps:
Locate the Learn Button: Press and hold the Learn button for about 6 to 10 seconds.
Observe the LED Light: The LED indicator will turn off, indicating that all remote and keypad codes have been erased.
Reprogram as Needed: Any previously programmed remotes or keypads will no longer work, so you will need to reprogram them.
Troubleshooting Common Issues
Remote Not Programming: Ensure you are pressing the Learn button properly and holding the remote button until the opener light blinks.
Keypad Not Working: Check battery levels and confirm you are entering the correct 4-digit code.
Garage Door Not Responding: Verify that the garage door opener is powered and that there are no signal interferences.
Accidental Code Erasure: If all remotes stop working, you may have inadvertently erased all codes. Reprogram them using the steps above.
Safety Tips When Using the Learn Button
Avoid Holding the Learn Button Too Long: Holding the Learn button longer than necessary may erase all programmed devices.
Keep Remotes Secure: If you suspect a lost or stolen remote, erase all codes and reprogram new ones.
Use Compatible Accessories: Always check compatibility with your specific LiftMaster model before purchasing remotes or keypads.
Test After Programming: Always test remotes and keypads after programming to ensure proper function.